(Imported from old site; original post: Thursday, May 10, 2012)

Okay. So setup took a bit longer than expected. Let’s just say that I had some shelving issues, and I had to fabricate a turnbuckle system that would tighten up the shelving in a way that it wouldn’t buckle outward when the printer was sat on it (yes, it’s that heavy). And this was even with a steel shelf frame around each of the shelves!

And then there was the networking issue. Practically have to be an IT expert to get that solved…luckily, there was one in room. This guy.

But anyway, it’s set up now, so, time to run a part!